DBC RED & BLUE LS SWAP ECM

Doing an LS Swap? Need an ECM to Run It?

Build a ready-to-run ECM for your LS swap by selecting your engine, transmission, throttle type, gear ratio, tire size, and other setup information from the options below. Your selections provide the information needed to configure the ECM for your specific combination.

Important Information

This service is designed for stock engines and transmissions. Custom tuning for aftermarket camshafts, fuel injectors, forced induction, or other performance modifications is not included. Vehicles with these modifications may require additional tuning after installation.

Your ECM will normally be programmed and shipped within 2–3 business days after purchase.

Programming Included

Every LS swap ECM will receive the following:

• Vehicle Anti-Theft System (VATS) disabled

• Rev limiter raised

• Speed limiter raised

• Swap-related diagnostic trouble codes disabled as appropriate

• Programming configured for the customer’s selected engine

• Transmission settings configured

• Throttle type configured

• Gear ratio and tire size entered if available

• 
  

Used ECM Condition

All ECMs are used original-equipment units—not brand-new components. The ECM you receive may have minor cosmetic wear and could be slightly dusty, dirty, greasy, scratched, or marked with writing. These cosmetic conditions do not affect its intended operation.

Emissions and Legal Compliance

Some Emissions-related systems and settings will not be disabled or altered for lawful reasons. The customer is responsible for ensuring that the vehicle complies with all federal, state, and local requirements.